well onto the cpu block
 

i made a gpu block for my 6800 gt...now i wanna make the cpu block....got a nice over clock on the 6800gt btw 460mhz 1300 on the ram stock was 350 1000....any ideas on cpu design?...i'm using 3/8" copper flat stock and 1" thick UHMW for the top...just looking for clews on how to mill the inside of the copper for a 939 proc...i can use the standard drill dremel...but i think i want kind hell i dunno gimme some suggestions please!

Re: well onto the cpu block
 

i guess it's all faded out lol well imma take a pice of what i got and upload it in a few...i dont wait around to do stuff much =\ i got 130 holes in the block lol....ehh yea...so i guess all the flow is gonna come from the top then into the holes...one side will be restricted flow one side full flow...hope it works out good. if not i have to go buy some more copper =\

Re: well onto the cpu block
 

I was happy with it. http://www.procooling.com/index.php?...icles&disp=128

Re: well onto the cpu block
 

not exactly what i got goin here...lol let me upload some pics...
http://members.cox.net/pepsi-/wb/08-07-06_1958.jpg
http://members.cox.net/pepsi-/wb/08-07-06_2211.jpg
http://members.cox.net/pepsi-/wb/08-07-06_2212.jpg
http://members.cox.net/pepsi-/wb/08-07-06_2219.jpg

Re: well onto the cpu block
 

it's so shiny i think it did a good lapping job on it.... went 2000 grit with mothers to soften the copper while lapping...

Re: well onto the cpu block
 

very nice

Re: well onto the cpu block
 

well i guess this is the finished product...
http://members.cox.net/pepsi-/wb/08-07-06_2331.jpg

http://members.cox.net/pepsi-/wb/08-07-06_2332.jpg

http://members.cox.net/pepsi-/wb/08-07-06_2333.jpg

Re: well onto the cpu block
 

i think i need a better pump....this block is reducing my flow alot! only a 32 gph pump though...

Re: well onto the cpu block
 

i don't think i am getting a very good temp on this....it's groin from my cpu block to the gpu block....then back through the loop with a heater core....cpu temp is 38 c its an athlon 64 3000+ at 2.4 ghz so 600 mhz oc and the gpu block is 48c is this good or bad? this is my first water cooling setup and i made everything from scratch...so i have no clew what kind of temps to expect....and its a 32gph 12v electric fuel pump...*sigh* i jsut dont know i think my cpu was running cooler with the heat pipe heat sink i had on it from cooler master but i dont remember the temps=......i'm basing these temps off of asus probe though i dont know how accurate that is.