need help for cpu wb
i want to bild wd for 939 cpu
i need to know the dementions of the block and how deep is the cutting |
Re: need help for cpu wb
Question #1: What tools do you have free access to? That will largely determine where we go from as far as recomendations.
Typically your raw material for the base of a waterblock is 1/4" or less and your channel depth will be no higher than 3/16" or 4mm. The 939 socket area can fit a 2"x3" base, but around a 2"x2" base size is more typical. |
Re: need help for cpu wb
Edit: CURSES FOILED BY THE CAPTAIN!
Thread stickied at the top of this forum for the express purpose of mounting dimensions. http://forums.procooling.com/vbb/showthread.php?t=8412 Look on the last page. Captain Slug and others may be able to help you more than I. |
Re: need help for cpu wb
could you write it in milimeters?
|
Re: need help for cpu wb
Includes both
http://www.captainslug.com/modding/mh.gif |
Re: need help for cpu wb
if i want to make it round what diameter i need to cut it
i have msi neo 2 platinum board |
Re: need help for cpu wb
I don't recommend going any larger than 2-1/4 inches in diameter. 2-1/2 might fit but you'll have to check clearance around the socket.
|
Re: need help for cpu wb
thanks
|
| All times are GMT -5. The time now is 05:08 PM. |
Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
(C) 2005 ProCooling.com If we in some way offend you, insult you or your people, screw your mom, beat up your dad, or poop on your porch... we're sorry... we were probably really drunk... Oh and dont steal our content bitches! Don't give us a reason to pee in your open car window this summer...