Help on DIY VGA block..
 

Hello.

I dont know if this is to much to ask for but if there is anybody that can help me on doing a waterblock for my MSI NX6600GT card..
I dont know distance to mounting holes and such, dont know if I should go with a full cover block or just for the GPU.. And it cant be to thick either due I got a Shuttle so it can only be about 23-24mm thick..
Hope you guys can help me out a little bit..

Best regards, JAxen..

Re: Help on DIY VGA block..
 

What does doing a waterblock mean....buying one or making one?

Re: Help on DIY VGA block..
 

Mad bad..
I want to make it myself and I was hoping that I could get some help over here..

Re: Help on DIY VGA block..
 

Why not use a bit of styrofoam as a template? Place foam where block should go, and punch through the mounting holes from the backside. You will end up with a piece of styrofoam that can show you exactly where the holes should be.

Re: Help on DIY VGA block..
 

These dimensions are taken from an eVGA 6600GT
Measured by caliper. Hole diameter is 2.5mm

Re: Help on DIY VGA block..
 

Well, it shows out that I cant mill this kinds of thing anymore :[
So if anyone of you know where I can get a waterblock for my MSI NX6600GT I'd appriciate a hotlink to that place :)

Re: Help on DIY VGA block..
 

The thinnest block I can find with a quick google search is this:http://www.quietpcusa.com/acb/showde...D=277&CATID=13

20mm thick it says?

Re: Help on DIY VGA block..
 

http://www.petrastechshop.com/sicyfugpuwa.html

silver prop 19mm height

http://www.petrastechshop.com/q.html
25.2mm is too big but you can trim 1mm off the acetal

Re: Help on DIY VGA block..
 

Thanks a ton guys..
About Danger Den maze 4 block, I didnt see that it would fit an 6600.. Does it fit anyway?

Re: Help on DIY VGA block..
 

Probably fit but I think it is thicker than 24mm. Maybe not...

Re: Help on DIY VGA block..
 

Yeah but that is no problem if its about 1mm too thick.. Aslong as the mounting holes fit..