WC finally ready.... :-)
 

so my first WC setup is a fact.

black ice 4*120 radiator extreme
innovatek HPPS plus 12V pump
alphacool nexxos X2 plus for the CPU
aquacomputer aquagrafFX 9800GX2 for the GPU

unfortunatly i was unable to mount the 790SLI mainboard kit cause off the VR cooler interfering with an extra 12V connector on the mainboard (asus strikerII extreme).

loop is : rad--->PUMP---> CPU-->ASUS MoBo FUSION block(NB/SB/VR)--> GPU

temps idle :

CPU : 32°c
GPU1 : 39°c
GPU2 : 45°c
water in :25.8°c
water out : 24.7°c
case temp : 22.5°c

temp full load :

CPU : 39 - 40°c
GPU1 : 45°c
GPU2 : 49°c
water in : 28.8°c
water out : 27.7°c
case temp : 22.5°c

flow is about 1.13 l/minute (but i think the flowmeter isn't quite accurate)

i have used tygon ID 3/8" OD 1/2" and all G1/4 fittings

only 2 90° fittings on the GPU card.

i always get only a 1°c difference between in and out watertemp no matter what settings i use;dunno if it's good or bad ???

i'll try to post some pics if i can.

Re: WC finally ready.... :-)
 

Yes, thats normal. Once water reaches equilibrium the temp should settle at a certain point depending on load and air temp...


Temps look good.