dual slot 1 cooling
 

what should i get for a cooling system.? do the ocwc waterblocks need the sandwich looking bracket or can i just use those nylon bolts

The OCWC blocks are probably too tall. I'd go w/ the dangerden blocks w/ straight fittings.

Someone needs to start producing kits cathering to Dual CPU combos either Slot or Socket. Even though it'll proably be crappy it still would be a good starting point.

------------------
Watercooled K6-2 450 at 600

I ordered two DangerDen waterblocks with the 90 fittings. They work ok, all I need now is to get is two "Y" adapters to make it a little more effeicent as far as moving water, right now the plan is to just have one jump to the other in a series. I got a Dual 933 on an Abit VP6, this weekend goes the watercooling.

Damn... that should be a fun setup to play w/!!

is becooling any good??
Heres a breakdown of the parts i might get from them:

1 Aquacube 49.99
2 copperwaterjackets w/straight fittings 55.98
2 sandwich bracket kits 15.98
5 3ft tubing (15ft piece) 9.95
1 single radiator 28.99
1 fan mounting kit 1.99
2 coppermine shims 7.98
2 3/8" Y connectors, nylon FREE w/order

Total $170.86

-by the way this is on a tyan tiger133 so the procs are pretty close to each other

[This message has been edited by rumblefish (edited 02-23-2001).]

Hey dude since you have dual slots try these people out. http://www.swiftnets.com , take a look at the MCW2001. The kits come as shown in the picture, looks like nice insulation to me, anyhow, they are a little expensive for each complete waterblock/pelt then other companys :-(. Also if I were you I would stay away from submerged pumps, if you got the room just get an external pump like a mag drive 250 and a 4x4x4 resivor it cheaper too

thanks for the input guys