Will Dangerden clamp fit OCWC polyblock?
 

I have one of the origonal OCWC copper polyblocks(before they had socket A mounting holes) and and as it is configured it in a new system the provided clamp will not work. I tried making a socket A clamp out of plexi but it never worked right. I was wondering if anybody knew if the Dangerden plexi clamp at www.caseetc.com would fit. Thanks

what block was the dden one designed for?

is the dden block and the ocwc block the same size, or a similar size?

i dont know if it will unfortunantly...
the dd clip uses a spring construction and this is not variable in height.... if the other block is higher or lower it´ll give you crappy pressure or more pressure than you cpu or lugs can take....
construct your own clamp instead. it aint that hard when you put your mind to it... look over att overclockers.com they have some form of diagram of one that might work for you.