Asus P4T-e OC problems
 

I got my water cooled case and new system built and running. I am at 2640ghz with a FSB of 120. I pumped the Vcore to 1.85 from 1.5 on a Northwood 2.2 P4.(wire trick) I am suposed to be able to get up to around 142 fsb. I cant get it to run at 133 FSB. I can boot at 133, giving me a CPU of 2.96 ghz. But after a few min I blue screen. This setting only puts me .2-3 hz more on the AGP and PCI bus. I cant pin point it yet. The best thing is that I can run my system like this at 100% load and I ave about 36-39 Deg C. My GF4 is running at 320 GPU and 710 mem also and is about twice as cool with the water block on it also.
Any ideas?


My P4T-E is the good one too with eteh ICS clock generators also. This is supposed to be the "real overclackable " P4T-E Asus board.

run your ram at 3/4 speed, see if you get any higher

I have put it at 3x and at auto ( the lowesed setting and I have the same problem. The strange thing is I have made it up to 125 FSB which puts my PCI and AGP wayyyy out of spec and it is running fine. But my mail goal was a 133 FSB, I cant get it to run for more thatn 15 seconds there. At 133 FSB I lower the PCI and AGP slots back to almost default specs too. I has to be a crappy CPU or somthing with the memory I guess. On some of the OC forums, there are guys running at 142 + fsb withe teh 1.85 Vcore I have no problem. Sigh...

might be bad drcg's, bad ram, bad cpu. Whats the cpu temp?

32 at idle 39 at load

hmmm, what drcg's do you have?

What are those of you dont mind my no0b ass asking :)

little ic's next to the 1st ram slot.