Condensation Prevention Theory
 

humm. my friend had this idea i want to share with you all and see if its possible to implement.
He uses watercooling system with a peltier so his idea to prevent condensation is to overclock the processor so it would get soo hot that it would equal or be above ambient temperature. I think that would prevent condensation on the processor itself but i doubt it would prevent it on the peltier. Any ideas?

Sonix. If you use a peltier that can barely handle the load of your cpu such that it cannot produce temperatures below ambient, you will not get any condensation anywhere. But, this is not really effective use of the peltier and would put a lot of stress on it, and may cause it to fail.
-Zoson

i get what your trying to say... if you make the Peltier work hard enought it wont have the power to get cold enough to do that i guess. doesnt sound like a good idea to push something that hard to save a coupple bucks. just do it the normal way ;)

i'm worried about the stuff leaking and letting water particles through after a long period of time.

well every once in a while you can take your computer. dust it off and make shure there is no water. a computer needs to be cleaned every once and a while, you can get a lot of dust in one of those.

umm i was talkin about the sealant

i r smartz! i dont think you really have to worry about if you do a good job at it.

Not even close, that idea defeats the whole idea of cooling the damn cpu. think about it. If you do things "right" you won't have the problem. No air in or out of the enclosure, no condensation.
Good Luck!!!!!!!!:)

I found out another way to prevent condensation problems (notice I said the problems, not condensation).

My latest attempt to keep condensation away with my system didn't work (with my water chiller setup). As I was sitting in disgust about the failure of the $36 worth of neoprene I had carved out, I decided to see if kept everything cold enough to freeze the condensation if maybe ice doesn't conduct electricity.

So I let my cooler get the temperatures down to -28c (with the computer off) and put a fan blowing on the insides of my computer (to help evaporate anything on the outside).

I turned it on and it worked fine, now this will only work if your cooling solution is able to keep things very cold even when running full speed (which luckily mine can keep things at -16.5c full speed), otherwise your ice will turn back into water and you'll have the problems again.

Anyhow I though I would share my discovery with ya'll.

-Sidney