Cramming a ton of cooling into a PC60.
 

I've finally 'completed' my rig. Maze3, DD Cleartop Chipset Block, DD GF4 Block, DD Cylindrical Reservoir, Black Ice Xtreme, Black Ice Micro, ViaAqua 1300, and Tygon 1/2"ID 5/8" OD all crammed into a Lian Li PC60. I haven't seen anyone with more watercooling crammed into a PC60.
http://160.39.128.50/Pictures/guts-s.jpg
http://160.39.128.50/Pictures/windowdark-s.jpg
http://160.39.128.50/Pictures/caseangle-s.jpg
http://160.39.128.50/Pictures/frontstealth-s.jpg
-Zoson

NIIICE setup zoson!!! What kind of shoe horn did you use:D

ooops, my dad owns such a case and he is using TT volcano 7 or something. always bitching about the noise. i was thinking, lets get him some H2O goodness, but after a quick look it seemed impossible to cram it all in the case. and u indeed succeeded in cramming double the amount of cooling components in there that i would have used.

gr8 job

although it must suck to replace a pci, agp or mem stick

heheh, it really sucks to try to put something new in! So I've gone over the basics and I'm not going to upgrade for awhile ;). Geforce4 ti4600, usb2, tv, audigy... I think I'm good for awhile...
It's like a puzzle, it only goes together one way, and can only come apart in the reverse order. And I have to empty my lines every time :(.
-Zoson

It's taken me quite a while to finally figure out a layout that will allow me to fit everything I want to into my case (and thats quite a bit). I don't have the motherboard yet though (low on $$) so there will still be a bit of adusting later on.

I am considering going dual-pump though... so that might just screw it all up:p


Nice system though :D I would try putting some small valves in so thaty you don't have to completely drain the system each time you need any maintenance.