Fittings for Danner Mag
If I am going to run a Danner Mag submerged, does anyone know about how far the fittings extend out from the exit of the pump? I am just trying to see if it will fit in my res! Thanks!
|
If it is submerged, you should only need a fitting on the exit side. This is the top hole on the impeller housing. For mine, the fitting extends about 1 3/4" up since I could not thread it on all the way.
As for fitting in your resivoir, wouldn't you want the exit fitting accessible on the outside to connect a hose to it? |
the only res it will fit in is a 6X6X4 res
tried it and it barely fits.... you have to mount it sideways in there w/ a 90 degree plumbing fitting. it is very tight and will add heat to the system. that is y i decided not to go ahead w/ it. |
| All times are GMT -5. The time now is 05:32 PM. |
Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
(C) 2005 ProCooling.com If we in some way offend you, insult you or your people, screw your mom, beat up your dad, or poop on your porch... we're sorry... we were probably really drunk... Oh and dont steal our content bitches! Don't give us a reason to pee in your open car window this summer...