Blockdesign Socket A
 

Hi evryone, i would be very happy if anyone could make a drawing (blueprint) for a water block! Cpu AMD Athalon 50x50 mm for just the bottom, gonna use plexi for the top.
And one design for Gpu Gforce2 35x35 mm. will use plexi for the top there to. (The height for the block´s i don´t know)

the material i have is going to last for 4 blokcs (2 Pc:s)

The copper is 50x50x300mm

The mill is not controlled by CNC and i don´t think it can make round corners.

need a simpel well working design with one inlet and one outlet.

my mail:
vbgprince@telia.com

IF you're not into round corners, I'd go with what Plawsworth advanced, unless 45 degree cuts are out too, in which case, I'd point you towards a Maze 1 type block. Again, I'd propose adding fins over the core area, to improve cooling some.

This should be "good enough" to get you up there with the rest of the top commercial blocks.

Thanks m8 ill keep on doing my drawnigs =)