waterblock in construction... whadya think?
 

I'm in progress of cutting the fins for my waterblock, about half done. I've got a sorta interesting setup to cut the fins: a lathe modified to cut all 3 directions, with a dremel diamond wheel. The wheel cuts about 0.5 mm thickness, and i'm cutting to a base thickness of about 1.5 to 2.0 mm, fin height of about 7 mm. I'm going to cut fins to the slant and the start of the channels, then chop off the copper that isn't used at the one end. Is 0.5mm ok for the fins, or should I cut a little thicker to allow the water to flow more easily?

sorry for the bad quality... What do you guys think so far?

http://www3.telus.net/hellfire_inc/l...ting%20001.bmp http://www3.telus.net/hellfire_inc/l...ting%20009.bmp
http://www3.telus.net/hellfire_inc/l...ting%20013.bmphttp://www3.telus.net/hellfire_inc/l...ting%20010.bmp
more pics here http://www3.telus.net/hellfire_inc/

nice looking, its pretty similar to morphling's desing, i hope it works as good as his.

I think you should change that pic to jpg format, posting in bmp is a bandwidth crime! :mad:

hehe
 

ya, when it's such bad quality anyway...:p

change the to JPEG plz! anyhow, it looks good so far.