Flow rate vs pressure drop curve for 1/2" ID tubing
 

Hello all,

Does anyone out there have such a table? I did a search and couldn't find anything. I know that BB2K posted some info about that once, but that was a long while ago and I couldn't dig that back up. Also, if anyone has curves for other diameters of tubing, that would be nice to have around too. Thanks,

BO(V)BZ

I don't have any books in front of me (at home), but I have an engineering program that I use to estimate flow losses, etc. It lends itself very well to hoses.

If you want to post your specs then I will be glad to run a simulation for you. Take a look at the interface HERE to get an idea of it's capabilities and required inputs.

edit: some fields are dual-units, only one needs to be completed.

been posted here
dig through my old posts, possibly in the sim section