Athlon 64 FX Waterblock design -Cascade style
Ok, I have my 5950 waterblock designed, next I need a waterblock for my Athlon 64 FX51
After tons of research I have decided on a cascade style block. http://www.zapwizard.com/laserpc/fx51/fx-1.jpg http://www.zapwizard.com/laserpc/fx51/fx-2.jpg http://www.zapwizard.com/laserpc/fx51/fx-3.jpg The entire thing may be slimed down and made entirely of copper. (To match my 5950 Block) The copper jet tubes may simply become normal plastic tubes. |
Re: Athlon 64 FX Waterblock design -Cascade style
Quote:
Looks great! What is the inner diameter of the jet tubes? Do you have a 3D model of the A64 socket? |
Re: Re: Athlon 64 FX Waterblock design -Cascade style
The tubes will probably be just under 2mm(Inside), the holes in the copper are 3mm.
I don't have a model of the socket, I just measured the height of the heatspreader above the motherboard. The heatspreader is 40mm x 40mm |
Re: Re: Re: Athlon 64 FX Waterblock design -Cascade style
Quote:
Ok, that's not-too-hard to be machined... I intend to make a good, exact model...it's always useful.... |
any reason why you have 3 pipes?
go for 2 pipes and angle them a bit more flow friendly. looks very nice though :D |
ZapWizard,
Get rid of the 90ยบ turns just into and out of the block... unless you ABSOLUTELY need them to clear some hardware. :eek: |
| All times are GMT -5. The time now is 04:09 PM. |
Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
(C) 2005 ProCooling.com If we in some way offend you, insult you or your people, screw your mom, beat up your dad, or poop on your porch... we're sorry... we were probably really drunk... Oh and dont steal our content bitches! Don't give us a reason to pee in your open car window this summer...