Finally set up my pelt :D a quick question too...
 

I finally got the courage to put the pelt on my wb. I have a Maze4-1 with a 226w pelt, amd t-bred b 2100+ o/c'ed to 212x11 @ 1.9 vcore, temps are 20c idle 30c load. I have a decent sized heatercore, with a shroud for 2 fans on one side, and a danner mag3. No res, closed loop. I'm running it off a enermax psu w/ 33a on the 12v rail, but I'm wondering if these temps are normal for my setup.

Is it common to get a higher overclock at a lower vcore, since temps are lower? I lowered the vcore and moved the fsb down to 166, and got down to 16c. I haven't tried overclocking at a lower vcore yet, I was just wondering how you pelt guys go about things. I tried upping the vcore to 2.0 and raising the multi, but it didn't get too much more stable around 2.4ghz. Thanks.

as far as i can tell if you are using the 12volt rail from a power supply that supplies the power to the rest of the computer then yuo probly aren't getting enough power to the peltier

Sorry, I didn't mention that the enermax isn't running my comp. I have an antec truecontrol 550 for that.