Tygon Tubing
 

-10 feeet of Tygon R3603 tubing (3/8ID, 5/8OD, 1/8 wall). The best you can get for tubing. Never used, one long 10 foot piece, super shiny stuff.
-Selling Glowmotion Blue UV dye, about 10 ML of 50 ML used. Glows bright with ClearFlex or Mastercleer, you'd need brighter Cathodes with Tygon Tubing.
-Selling UV Duel cathode lights. PCI slot switch. 10.00 dollars from CompUSA.

I will sell all three for 25.00 shipped

http://www.zetaphirhouci.com/randypics/16.JPG

-77 Bonneville heatercore with black aluminum shroud (slight scratches, can be painted easily) with 3/8 inch barbs. Used with an MCW6000 and 1048 which produced better temperatures than my old 1/2inch TDX setup (which was WAY noisier). Comes with mounting screws already within the fins (we all know how hard it is to put those through) and 4 fans! (2 panaflos and 2 deltas, on a rheobus very quiet)

Value: Radiator: 30.00
Shroud: (just cost of materials since its self made) 15.00
Panaflos: 23.00 (these are the 120x38mm ones)
Deltas: 8.00
Value = 76.00
Asking = 55 dollars shipped

-can be replaced with 1/2 barbs if you REALLY want it. But the paint would be messed up since I have to torch it, just give 3/8 inch tubing a try though, it's so much better!


http://www.zetaphirhouci.com/randypics/3.JPG

Deal, if you buy everything (rad, plus tubing, plus UV dye, plus lights) I will sell all for the value of the radiator. 76.00 dollars shipped.



heatware is quicksilverXP
paypal is rtorio@uci.edu

added stuff

the pic didint open here.
Is it 3/8 ID or 5/8 ID ?

sorry, its 3/8ID, and 5/8OD

added radiator

Is the UV additive clear under normal light?

It is supposed to be visible, but it isn't really. It did give my FlluidXP a slight bluish hue, but not noticeable until looked at closely. It's very blue under UV light though..