need a contact at watercoolplanet.de
 

want to send those fellows a wb
anyone know who runs the wb testing part ?

their contact info

PS: Its a German site and Crew. I speak german and would be happy to translate the letter you will prepare fro them.. Always happy to help the WC market!!

I know a bit of german too. Enough to:

Order 0,5l beers
Get directions to the toilet
Tell cab driver to get me to airport

That seems to be the bare minimum for successful two weeks in Vienna anyway :)

Thanks
we shall see . . . .

Planning on showing off there Bill. :D

Or are you trying to cross reference some data to determin exactly what they are doing on that test stand?

lol :thumbsup:

lol
many a slip twixt the cup and the lip
if they don't wish to come to us, we shall go to them
(but note they do have the RBX, etc. - not too hard to extrapolate how this should play out)

they clearly state that the test setup is what it is, and no more
lets just hope it is used in a consistant manner (I can find no actual test raw data)

SC
I hit them in English, if I get German back I'll PM you
Thanks

MCW6000 should do well there given the 0.25-0.5 L/min flow rate

my thinking too,
they would die if I sent them a 1/4" version for those 1046 pumps (0.4°C lower temps), we have not yet decided if to produce just for Europe

http://www.finclockers.com/artikkeli.asp?id=136&s=9
anyone have a Finnish translation link ?

Would it be so hard to add a little plastic quick connect adaptor? Just slide it over the 3/8" barbs...

How hard is it to guess what Finnish means? I'll be back shortly, probably flustered and confused.

I find it hard to believe that an Antarctica would beat a 6000 even with a Compact 600 Eheim thing...

Damn that's hard to read.

remember AA, if the wbs are (truly) close the posted result is chance - nothing more
not enough mountings are done to remove the TIM joint as a variable

Any thoughts whether 0.05 or 0.1 on a 10x10 mm die would be more appropriate

that range, aggresive/risky -> conservative
ohh
no, the above is correct for a highly skilled and experienced individual working on the same bench, or mass production under controlled conditions
DIY on a mobo in a case could easily exceed 0.2

if you are asking what value might be appropriate for the WCP 'results', haven't a clue