Quote:
|
Originally Posted by killernoodle
Can the tubes take the corners without the springs in there? If so, take them out. If you dont mind the temps much, then just leave em in there. It isnt like removing the springs will make this kit as good as a pro kit, so dont worry about them.
|
I think it will take the bends without kinking and without the springs which I was planning on leaving out as common sense told me it would restrict flow.
But I wanted a professional opinion and if the pros told me it woud have no effect----then I'd leave them in as it does give the tubing more strength.
As for building my own setup----I think you are correct and if I shopped around, I could find a better small pump and a better small radiator.
It's size that is the problem in the SFF boxes.
Perhaps we should issue a challenge to forum members and have them come up with the best or a recommended solution for watercooling SFF machines like the Biostar IDEQ, Shuttle XPC, Soltek Qbic---etc, etc.
Causes the engineer to accept tradeoffs----size for performance-----and what then is the best performance for the size available......
The SFF machines are becoming hugely popular.
Thanks for the help,
John