Personally
1. I don't like the rad mounted up in the top. Why? All the hot air being curculated around in the case is exiting through the heater core (pre warmed air cuts the abilty for the heater core to exchange heat.
2. looking at the swifty Block, the feed is going in the top and exits out the bottom. This could make an air pocket and give you trouble.
3. Must be a pain in the arse to fill with the fill point being the lowest part of the loop.
It looks nice and clean but that is what I see as potential problems.
Don't let me discourgage you, this is not an attemp to put you or your plans down, just pointing out potential problem areas.
Aardil
|