Pro/Forums - View Single Post - Watercooled Antec Truecontrol, voltage on the blocks.

petter · 02-04-2004, 05:29 AM

Hi all,
I have just finished up watercooling my Antec Truecontrol 550W PSU, pictures can be seen here:
http://www.nskjaer.dk/antec/
Now for the problem, there runs current though the heatsinks, alot of current. I have touched them and felt nothing (before I knew how much current it is), I have also connected the to with a piece of wire, no problems there, but there was still a current across the heatsinks.
The psu is running fine, the rails are very precise, so the currentproblem does not affect the rails.
The original heatsinks were live, the new ones are not. I have isolated all components and cannot see where the blocks are in contact with anything that has current running through it. I have watercooled other PSU's without problems, is there something special with Antec?

02-04-2004, 05:29 AM	#1
petter Cooling Neophyte Join Date: Aug 2002 Location: Denmark Posts: 16	Watercooled Antec Truecontrol, voltage on the blocks. Hi all, I have just finished up watercooling my Antec Truecontrol 550W PSU, pictures can be seen here: http://www.nskjaer.dk/antec/ Now for the problem, there runs current though the heatsinks, alot of current. I have touched them and felt nothing (before I knew how much current it is), I have also connected the to with a piece of wire, no problems there, but there was still a current across the heatsinks. The psu is running fine, the rails are very precise, so the currentproblem does not affect the rails. The original heatsinks were live, the new ones are not. I have isolated all components and cannot see where the blocks are in contact with anything that has current running through it. I have watercooled other PSU's without problems, is there something special with Antec?