Quote:
|
Originally Posted by joemac
I don’t think the base is thin through out the entire block. I think the only thin part of the RBX and the WW is over the core in which case the probe hole can be made to be stop just outside the valley of the block. This should prevent affecting the performance reading of the block (most user only care about the reading above the core). Frankly without the proper insulation on the test, this should remove more variables than it introduces.
|
IF something like this was to be done, it would mean the temperature probe will not be at the same position (in respect to the core) for all wbs, wich will make any datas useless for any wb to wb comparison.