Whew... long day today... so not as much done.
I received the cap screws today in the mail from
microfasteners.com.
To give you an idea of just how small the "0-80" cap screws are...
(Ati All-in-Wonder 9700 Pro in the back for scale)
Close-up...
And... measurements...
Also got the Acrylic piece for the top of the reservior and drilled and tapped the holes for the "4-40 x 3/4" cap screws. You can see two of them in place.
The white "stuff" is white "Silicone II" Bathroom Tub & Tile Sealant. Old, but still good in the tube. I'll let it cure about 24 hours and pull off the intake cap and peel off the "gasket" and trim it up. Then it should be ready to assemble again. I also still have to mill the holes for the two return tubes.
That's it for tonight... more tomorrow.
