View Single Post
Unread 02-21-2004, 11:30 PM   #1
pelikan
Cooling Neophyte
 
Join Date: Jan 2004
Location: California
Posts: 8
Default Modifying DD R9700 block

I'm considering milling out the copper in the middle of the block so that its just an open chamber. Then I would drill some holes, rotor style, to make turbulence.
I think this would increase the flowrate and cooling ability of the block. But without a guide in there to control the flow, water may slow down and heat up in the corner away from the barbs.
Opinions? Suggestions?
Thanks.
__________________
2500+ @ 2500MHz, NF7-S, HyperX, 9800 Pro, Raptor, Cold Water
pelikan is offline   Reply With Quote