View Single Post
Unread 02-24-2004, 11:51 AM   #6
|kbn|
Cooling Savant
 
|kbn|'s Avatar
 
Join Date: Feb 2004
Location: W. Sussex, UK
Posts: 329
Default

removing the middle channel will make the block a lot less restrictive and you will get higher flow rates from the other blocks in your sytem, but i dont think it will perform any better atall as the water will go over the holes and not be forced into them.

i still think removing the top barb, and drilling a few holes down into the middle channel would be the best way to increase performance, though i dont think it would be particually easy to do..
|kbn| is offline   Reply With Quote