View Single Post
Unread 02-24-2004, 03:17 PM   #15
SysCrusher
Cooling Savant
 
SysCrusher's Avatar
 
Join Date: Dec 2002
Location: Florida
Posts: 256
Default

Quote:
Originally Posted by MMZ_TimeLord
Locked it in my mill and started cutting... First thing I noticed was that a two flute endmill has a tough time routing channels.
Cool thread timelord and not a bad job. The two flute just tries to cut too much and bites into the copper. Try a 3 flute or 4 flute with a little more rpm. I'd use the 2 flute for rough work and finish up with a 3 or 4 flute.
SysCrusher is offline   Reply With Quote