Quote:
|
Originally Posted by Jabo
Go for all pull setup and you'll be rewarded with MUCH better performance and saved space (well, depends with this space saving - you'll save on lenght and increase in width. My ballpark figure would be anything between 200mm and 400mm depending on fan's power and construction (focused flow Deltas are different kind of animal for example)
|
I can embed one fan right in the front bezel, then case frame, shroud, BIX, shroud, then Fan,
the fans i will be using are
Evercool Chrome 120mm Fan
80 CFM 2000 RPM 30Db 0.38A
Quote:
|
Originally Posted by AntiBling
Mine are both 3/4``from the rad on each side, in aluminum shrouds I made. I cant tell you if that is the best for cooling but its enough distance that there is no noise from the blades being close to it. I dont hear that HSF kind of whine you would expect if they were too close, even if I turn them all the way up to 2800RPM from their regular 900RPM
|
i think i have enough room for 3/4"
I'm also making them out of aluminum. I made one already but not quite happy with it... i start my design with cardboard.. then draw it out on aluminum once i get it shaped right.
thanks for your help.. hopefully i'll get time to work on it tonight
