Pro/Forums - View Single Post - Minimum distance from heater core to fan?

AntiBling · 02-26-2004, 07:49 PM

I made my shrouds by cutting out the shape of it in 1/8" aluminum, then I folded it to make the shroud. Along the lines where I was going to fold it, I used my dremel to etch out about half of the material. This made it so I could bend it right over in a straight line. Etch out the lines on the inside of the shroud and you cant see the cuts when you fold it up. Fast and easy.

02-26-2004, 07:49 PM	#5
AntiBling Cooling Savant Join Date: Jan 2004 Location: orlando FL Posts: 147	I made my shrouds by cutting out the shape of it in 1/8" aluminum, then I folded it to make the shroud. Along the lines where I was going to fold it, I used my dremel to etch out about half of the material. This made it so I could bend it right over in a straight line. Etch out the lines on the inside of the shroud and you cant see the cuts when you fold it up. Fast and easy. Last edited by AntiBling; 02-26-2004 at 08:39 PM.