Quote:
|
Originally Posted by TerraMex
You can.
Wrong position thou.
Use setting 1 (green) or 2 (red). Either works well.
The one you had would make the side channels get low flow.
Settings 1 or 2 manages to prevent that.
Best way , drill a hole, solder a copper pipe , or a barb. Not very difficult.
|
Well thanks for the tips! Could I use JB Weld or epoxy rather than solder. I dont know EXACTLY how to solder that type stuff.. only good in wires, not tubing. If you could explain how I would and what would I use to solder them on?