Quote:
|
Originally Posted by pHaestus
MMZ_Timelord:
If I may be so bold as to make a suggestion, I'd recommend tapping a small hole in the bottom (which is the highest point) of your heatercore and putting in a little needle valve and 1/8" stretch of hose....
|
I'm doing the same, but to make it easier to drain, since my inlet/outlet's will be at the "top".
I like this HDD block, but I would have used a flexible tube between the two plates. Maybe I'm just paranoid, and don't trust myself to get the spacing right. The funny thing is that it's not too late for you to do the same...
Excellent work! Thanks for the PM, and the tips you've shown us through this thread.