Another episode of "As the mill turns..."
First I had to drill and tap some new hold down's for the video card front block.
One more hold down and it's on to find the center of the first hole...
Then I drilled down 3/16" with a 3/32" drill bit (my 1/8" endmill is not center cutting...
)
On the third column here... You'll notice that some of them are slightly off center. This will not matter as the endmill will cut the full 1/8" out.
Here all the holes are predrilled for the #rotor section...
Got the three right-hand columns done. You can barely make out the #rotor turbulance pins... remember these holes that are being milled are only 1/8" (Just over 3mm)
My eyes were hurting from focusing on it... so I'll do some more tomorrow.
Good night everyone! Cheers!
