Pro/Forums - View Single Post

MMZ_TimeLord · 03-12-2004, 02:22 AM

-J-,

I want it restrictive in that area only BECAUSE of the core. Also, I want the flow restricted in these blocks as the main flow needs to go through the CPU block.

I'll do some calculations on the cross sectional area of the GPU passages around the #rotor columns and the inlet. I think you will find that they are VERY close.

As to the height differences between the GPU and the RAM...

It was mentioned by BladeRunner in a previous thread that dimension varies because of IC and solder ball height. The variance is quite wide making the dimension useless for all cards.

I could post the dimensions for my card... but this measurement will vary from manufacturer to manufacturer and from model to model. The variance is still to big, even of two identical model cards from the same manufacturer...

You'd be better off taking the measurement yourself.

03-12-2004, 02:22 AM	#78
MMZ_TimeLord Cooling Savant Join Date: Apr 2003 Location: San Mateo, CA, USA, Earth Posts: 433	-J-, I want it restrictive in that area only BECAUSE of the core. Also, I want the flow restricted in these blocks as the main flow needs to go through the CPU block. I'll do some calculations on the cross sectional area of the GPU passages around the #rotor columns and the inlet. I think you will find that they are VERY close. As to the height differences between the GPU and the RAM... It was mentioned by BladeRunner in a previous thread that dimension varies because of IC and solder ball height. The variance is quite wide making the dimension useless for all cards. I could post the dimensions for my card... but this measurement will vary from manufacturer to manufacturer and from model to model. The variance is still to big, even of two identical model cards from the same manufacturer... You'd be better off taking the measurement yourself. __________________ MMZ>TimeLord "Oooooooooh... that's gonna leave a mark!"