View Single Post
Unread 03-13-2004, 02:06 AM   #7
Turbokeu
Cooling Savant
 
Turbokeu's Avatar
 
Join Date: May 2001
Location: Brussels - Belgium
Posts: 232
Default

Quote:
Originally Posted by pauldenton
ah - my bad (i knew it was one or the other...)

p.s. i see you're not scared of using elbows in your run ...
No worries.

No, I'm not...
It's so easy to route your tubing and make your fill&bleed. The copper turns are 15mm OD - 13mm ID (1/2"), the PVC parts are 20mm ID (3/4").
With all the the elbows (11 !) in my setup I had a flow of 4.40LPM with my Maze3, and now 3.35LPM with my Cascade WB (remember that I use also a very restrictive AquaCoil II cube rad).
Not bad is my GF4400 (3 copper turns) and my digital Swissflow sensor which ID is 3/8".


The black part is the Swissflow flow sensor:


Overview in an earlier (unfinished) state:


CD
__________________
My website: http://www.turbokeu.com
Backup website: http://www2.turbokeu.com
My company: http://www.kdcs.be
Turbokeu is offline   Reply With Quote