View Single Post
Unread 03-18-2004, 06:42 PM   #11
jaydee
Put up or Shut Up
 
jaydee's Avatar
 
Join Date: Dec 2001
Location: Spokane WA
Posts: 6,506
Default

Quote:
Originally Posted by JFettig
oh balls dude, thats an insane deal! and dude, definately ignore jaydee you'll be able to do anything jaydee can and many times more 1/16" EM wont be a problem(anything smaller may)

Well I suggest you read up a little, get some aluminum scrap, get rid of that peice of cardboard on the table and a 1/4" end mill or bigger and take less than half the diameter of the cut at maximum with regular end mills.

Its looking like it might be a fun machine, I wish I had something like that!


Jon
You misunderstood my point about the 1/16" and less endmills. That is a monster machine controlled by YOUR hands. One little slip and that small endmill is gone. Not to mention viewing is going to be fun... It will most certanly handle it though and 100 times more than my little mill (Mills that size, but CNC controlled make my mill!). No doubt there. That's why I said it wouldbe a good facing/flycutting mill.
jaydee is offline   Reply With Quote