Quote:
|
Originally Posted by pippin88
Got half way through a hard drive waterblock on the weekend.
Couldn't go any further as I needed to come home and do a few little bits of measurement (Pipe length on motherboard side).
I've sort of had this design in mind for a while, but this really inspired me to finally do it: http://forums.procooling.com/vbb/showthread.php?t=9175
I plan to have the pipe on the motherboard side come back over to the other pipe to make pipe runs easy. |
Nice Job so far.. looks good...
I plan on making a HD cooler same style...
I have the same inspiration, thanks lolito_fr
have my copper on order.
how thick is your copper plate? what size did you use for your pipe?
I ordered 0.108" (12 ga.) copper plate plan to use 1/2"ID pipe.
Quote:
|
Originally Posted by MC
just to make it easier, you could use street-90's and omit the second solder joint. Less joints=less leak possibilities.
|
good idea... I have never soldered pipe together before...
the only experiance i have in solding is electronics and that is the bare minimal...
"If at once you don't succeed... try try again...
If then you don't succeed... erase all evidence that you have tried..."
so if this post becomes empty... I have fails and erased all evidence that I have tried.