Just a quick question for anyone with a BIP2....How do you guys have the fans mounted to it?
I plan to mount 4 120mm fans on this rad in a push/pull config. Only problem is that the mounting holes on the rad are too small for normal screws.
I've considered drilling out the holes to make them a little bigger so I can run a threaded rod through all the fan and rad mounting holes. Then use wing nuts on the outer surfaces to tighten everything up.
I've seen some rubber mounting
Sticks that could be used also.
Either of these routes looks to work good, but I will need to drill out the mounting holes on the rad for both of them. Is there another mounting option that I'm not seeing here? :shrug:
Thanks in advance for your help.
Jester