Pro/Forums - View Single Post

Ares · 03-22-2004, 05:09 PM

just been surfing around the site reading old threads and what not.

and I see the talk about reseviors and building them.

I guess I didnt really put thought into the basics.

a pipe resevior seemed simple but I suppose its actually very inefficient, wasteful, and difficult.

a square or rectangle is a much smarter design.

I understand what your saying, basicly the top becomes 4 quadrants, and your saying 3 fans and the last one holds the tube.

so, thats a good setup. but would the following be better, worse or the same?

if instead of 3 fans and one outlet, you did 2 fans, and 2 bongs. should have less air speed in each bong, but twice the area so the water doesnt combine and decrease surface area.

and use a Y pipe out of the PC to spray into the 2 bongs.

03-22-2004, 05:09 PM	#8
Ares Cooling Neophyte Join Date: Mar 2004 Location: atlanta Posts: 28	just been surfing around the site reading old threads and what not. and I see the talk about reseviors and building them. I guess I didnt really put thought into the basics. a pipe resevior seemed simple but I suppose its actually very inefficient, wasteful, and difficult. a square or rectangle is a much smarter design. I understand what your saying, basicly the top becomes 4 quadrants, and your saying 3 fans and the last one holds the tube. so, thats a good setup. but would the following be better, worse or the same? if instead of 3 fans and one outlet, you did 2 fans, and 2 bongs. should have less air speed in each bong, but twice the area so the water doesnt combine and decrease surface area. and use a Y pipe out of the PC to spray into the 2 bongs.