View Single Post
Unread 03-24-2004, 04:12 AM   #86
MMZ_TimeLord
Cooling Savant
 
MMZ_TimeLord's Avatar
 
Join Date: Apr 2003
Location: San Mateo, CA, USA, Earth
Posts: 433

Well... nothing got done yesterday... so today I did a little.

First I milled a shallow run on the passages that were at right angles to the table... and some small start around the upper portion of the #Rotor area. Also (after breaking 3 bits in the tiny holes) decided to put two of the larger cap screws in the area that the passage crosses over to the back plate.



Then I got fed up with the template... (3-in-1 oil was breaking down the 3M adhesive) ... so off it came (after I marked the corners of the block outline )



Then I finished milling the right angle passages to depth...



I'm going to try and get the rest of the water passage side done tomorrow.

Cheers!
__________________
MMZ>TimeLord

"Oooooooooh... that's gonna leave a mark!"
MMZ_TimeLord is offline   Reply With Quote