JFetting,
In regards to your question in Post # 96
Quote:
|
whats the outter dimentions of that peice of copper?
|
The pattern that I used is 4.5 inches X 4.5 inches. The same as the piece I'm covering today ... the Back block for the All-in-Wonder Radeon 9700 Pro.
Here I've started milling the passages into the curve. I mounted this on my rotary table from the get-go to make it easier.
Here I have the passages completed ...
Tomorrow I will drill the holes for the small cap screws and begin on the back sides of both blocks.
Cheers!
