View Single Post
Unread 03-31-2004, 08:46 AM   #20
MMZ_TimeLord
Cooling Savant
 
MMZ_TimeLord's Avatar
 
Join Date: Apr 2003
Location: San Mateo, CA, USA, Earth
Posts: 433

One thing to note for flow considerations... ream out the ends of any copper pipe/tube you cut with a compression cutter as it reduces your inner diameter somewhat.

I tend to make the ends of my copper pipe/tube taper OUT WARD even if I cut it with a hack saw as I want the water flow to be smooth until it gets interrupted with something like #Rotor areas, etc.
__________________
MMZ>TimeLord

"Oooooooooh... that's gonna leave a mark!"
MMZ_TimeLord is offline   Reply With Quote