Very interesting design. You have proved my comment wrong in the rip off thread about considering limits of manufacturing.
How well do you think it will perform?
Quote:
Originally Posted by |kbn|
For my cpu block Im going to use two layers of plastic for the top. The middle one can join the two outlets for a 1 in 1 out top layer.
Originally Posted by Pritorian
Wouldn't that just make the block more restrictive?
Originally Posted by jaydee116
Yes it would. That will add an extra 90 inside the block. A Y adapter would not. Still would rather it be done inside the block though. Easier to route hose and performance loss should be unoticable.
|
A plastic 90 has iirc about 1/3 more restiction than a copper 90 because of the reduction in size and also the bend on the copper is smooth while the plastic is a sharp 90. It should be possible if you can give it enough space, to make it have very little restriction.