look arond at the heatspreader market and try to design something similiar. one half of a heat spreader so you can clamp two together for doudle sided RAM or clamp a "blank" one on for single sided RAM. but basically use the same design for each a thin flat tube to clamps acrosss the chips and that's all you need.
o
|
| |
| |
| |
| |
| |
| |
/
o
Or if this is just in a server get a load of good quality heat sinks for the ram and change out all the extractor/intake fans to higher cfm ones (such as deltas).
__________________
1800+ @ 2247 (214x10.5) - STABLE, 512MB PC3700 TwinX Cosair RAM, NF7-S v2.0, GeForce3 Ti200
Parallel BIM, 120.1 Thermochill, Eheim 1048, Maze 3, Maze4 GPU, "Z" chipset, 1/2" tubing, PC-70: 5x120mm & 9x80mm fans.
Internet Server & second machine (folding 24/7): 512MB DDR RAM, XP2000+
|