Nope, as it says in my sig and in my other post, I have a mobile 2500+, so the locked multiplier isn't an issue. And the temps in my very first post were regarding my DFI, hence the part about me not changing my sig in a long time (3 months) to update my new specs.
The DFI Infinity and Ultra B boards will do 250Mhz FSB no sweat with the right RAM (BH-5, of which I have several sets, all tested to 245Mhz+), so with watercooling I am looking for a speed of 10.5*250 preferably, or 11*240 would also be acceptable.
I've been overclocking for a long time, so I know what to expect out of my hardware, and I bought each part specifically for performance. I'm just interested in getting the most out of this watercooling setup first, and when I know its performing as it should, then i'll concentrate on tweaking my stuff to the max.
So, once more (and I sincerely appreciate the replies Cathar, don't doubt me there) do you think losing the GPU block and replacing the MCP600 with the Eheim 1260 would make any noticeable difference in temps?
BTW i've added a housefan to the side of my case and idle temps are now around 32c (reported socket temps) at 11*235 w. 1.85v and an ambient temp of around 25c.
It's only because i'm a n00b to watercooling that i'm asking all the annoying questions, but rather ask and be a fool for a minute, than stay quiet and be a fool forever, eh?
