The thing I liked about the design was that it forced the water to 1st flow through all the pins before being routed around the core area to the outlet. If I cut more pins below the core where the outlet joined, then it'd no longer need to flow to the sides of the core since it would have a direct rout to the outlet, which I don't want.
I have a ton of plexiglass, would this be adequate for use as the top and middle section of that design? Also, what would you recommend I use for bonding the plexiglass to the copper, and should I use a gasket somehow in the mixture, or just use the bonding agent as a sort of seal as well?
|