I guess its not an issue if you dont mind bleeding it as necessary. Id rather engineer it so it doesnt need bleeding. You could put a bleed on it in many different ways, but when you can just turn the rad over and replace a few tubes it hardly seems worth it. BTW I also started out using the vinyl tubing, but after screwing around with it I switched to clearflex from Cooltechnica. Sometimes saving money on the tubing is more trouble than its worth.
Hows this...
Turn the rad over.
Turn the pump around so the res inlet is attached to the GPU outlet.
Pump outlet to rad inlet.
Rad outlet to CPU inlet.
You may not need your union that way either even with vinyl tubes.
|