Thread: Heat die construction, heater distance
View Single Post
Unread 04-27-2004, 03:00 PM   #7
bigben2k
Responsible for 2%
of all the posts here.
 
bigben2k's Avatar
 
Join Date: May 2002
Location: Texas, U.S.A.
Posts: 8,302
Default
Quote:
Originally Posted by j813
Just measured a Morgan1200 and a T-BredB1700+ with a conventional Caliper, the Duron is less than a MM the TbredB is about 1mm, correct if I'm wrong though.
My guess is it's not 1mm under the top.

Sorry for not answering your question.
Nice, but is that the measurement of how far the die sticks out from the top of the ceramic? I'm looking for the actual thickness of the silicone, from the top of the die, shaved down to the actual circuitry *inside* the die. Did you catch that?


Thanks Nico!
bigben2k is offline   Reply With Quote