Pro/Forums - View Single Post

#Rotor · 04-27-2004, 07:09 PM

Now, on that last one.... are you going to chill a TEC with it? if not, then remove as much of the holes that are not productive in cooling the core area or acting as defusing/collecting areas for incoming and outgoing fluids.

in other words if you are going for a 2 inlet block the hole pattern might end up looking like an hour-glass, with the thin part over the core....

I would go out on a limb and say that if my block in the test was of such configuration, it might have faired considerably better than the one tested, reason being that the hour-glass setup would much better concentrate the cooling to the location over the core...

04-27-2004, 07:09 PM	#11
#Rotor Cooling Savant Join Date: Feb 2002 Location: Dione, sector 4s1256 Posts: 852	Now, on that last one.... are you going to chill a TEC with it? if not, then remove as much of the holes that are not productive in cooling the core area or acting as defusing/collecting areas for incoming and outgoing fluids. in other words if you are going for a 2 inlet block the hole pattern might end up looking like an hour-glass, with the thin part over the core.... I would go out on a limb and say that if my block in the test was of such configuration, it might have faired considerably better than the one tested, reason being that the hour-glass setup would much better concentrate the cooling to the location over the core... __________________ There is no Spoon....