Pro/Forums - View Single Post - alterntaive to soldering-can't mill O-ring groove

buzzby · 04-28-2004, 05:50 PM

You could use some "instant gasket" it uses in engines to create a seal. Can't see why it wouldn't work. Just make sure the 2 copper plates are dead flat.

Why do you not want to solder. If you needed to take the block apart just blow tourch it!

Buzz

04-28-2004, 05:50 PM	#5
buzzby Cooling Neophyte Join Date: Apr 2004 Location: at home Posts: 35	You could use some "instant gasket" it uses in engines to create a seal. Can't see why it wouldn't work. Just make sure the 2 copper plates are dead flat. Why do you not want to solder. If you needed to take the block apart just blow tourch it! Buzz