I was at work for far to long today so I didn't get as much done as I had hoped.
I finished half the back the top and front, and cut the openings for the window and rads.
The case closed, it kinda looks like a TV.
A quick shot of the case with the "hood" up. The copper bar will be replaced by something like whats in a car. Thats my dog in the far left, I have no clue why shes sticking her tounge out.
Both rads are now in place. The panel over the rads is connected to the case. The lower half will swing out as well so I can access the pumps/blower/ect.
The airtrap. Its all bonded together except for the fittings. The design is based on BigBen's modified for use in a dual loop system. This will be the only point in the system where the CPU loop and the NB/GPU/HD/... will meet. Its made from 1inch PVC, I'm hoping it will slow down the water enough to let the air escape within a minute. If not no biggie, I rarely if ever drain the system.
