another layer of insulation? I think I will go check out the amature forums for a while. I assumed that the vinyl would insulate it (5 feet of it) I also have more tubing then I need so I could move things around a bit. OK so I will insulate everything, including copper on water block, and then see if that helps. If my temps drop somewhat I will then consider getting an in line pump. Since my pump is submerged and adding additonal heat. I guess I was under the assumption that insulation was nice to drop a few degrees but not needed. As for my temps, I have the sensor on the chiller, mobo, case, and one I placed under the chip. They tend to all provide somewhat accurate temps. Thanks for the help again.
|