Pro/Forums - View Single Post

bobkoure · 05-12-2004, 12:12 PM

Thanks for the info!
Hmmm... will have to think about whether I want to build a reader or buy a bay device. The Panaflo L1Aa that I use are noisier when undervolted with PCM than with a simple resistor/rheostat (just have 'em on the 5V bus right now).
Looks like that project would extend to soldering on a SMD, which my soldering skills, equipment and even my freak'in eyesight (don't get old if you can avoid it) aren't up to.
Bob
Edit: Will those Dallas one wire probes fit under the processor (AMD XP-mobile)? What if I use "frag tape" to attach it (will probably want to move the sensor to another processor... eventually.)

05-12-2004, 12:12 PM	#3
bobkoure Cooling Savant Join Date: Feb 2003 Location: USA - Boston area Posts: 798	Thanks for the info! Hmmm... will have to think about whether I want to build a reader or buy a bay device. The Panaflo L1Aa that I use are noisier when undervolted with PCM than with a simple resistor/rheostat (just have 'em on the 5V bus right now). Looks like that project would extend to soldering on a SMD, which my soldering skills, equipment and even my freak'in eyesight (don't get old if you can avoid it) aren't up to. Bob Edit: Will those Dallas one wire probes fit under the processor (AMD XP-mobile)? What if I use "frag tape" to attach it (will probably want to move the sensor to another processor... eventually.) Last edited by bobkoure; 05-12-2004 at 12:14 PM. Reason: add question